Océ Publisher 1.6 Configuration for using AcroPlot Repro™ (Océ Publisher 1.6)

Océ Publisher 1.6 Configuration Instructions for

AcroPlot Repro™ PDF & DWF^® to TIFF Converter

Although AcroPlot Repro™ can configure Océ Repro Desk^® Client Tools™ software through the AcroPlot Repro Setup dialog, you may manually configure it yourself. Océ Publisher 1.6 software will allow AcroPlot Repro™ to be defined as the processing engine for PDF only. AcroPlot Repro™ cannot be configured to process DWF^® or PLT files inside the Océ Publisher 1.6 software application.

We strongly recommend that you upgrade to the Océ Client Tools (Publisher) 2.0 which is a free program. The Océ Publisher 1.6 does not support multipage PDF files either using our AcroPlot Repro or Ghostscript. It will convert the PDF file but only the first page is shown in Océ Publisher 1.6. We recommend that you use our AcroPlot Repro interface to first convert the PDF to the TIFF files and then load the TIFF files into Repro Desk.

1.	Océ Publisher 1.6 typically uses the standard install of Ghostscript^®. To use AcroPlot Repro™ change the Ghostscript^® path to the AcroPlotRepro.exe file. In Océ Publisher 1.6 choose the Tools-->Options menus.

Océ Publisher 1.6 - AcroPlot Repro™ Configuration for PDF Processing Screen Image 1.

2.	Listed in the "File Processing" section choose the "Postscript / PDF" category to display the field for the path to the Ghostscript^® executable.

Océ Publisher 1.6 - AcroPlot Repro™ Configuration for PDF Processing Screen Image 2. - Ghostscript® Path

3.	To use AcroPlot Repro as the PDF file processor in Océ Publisher 1.6, change the path to AcroPlotRepro.exe where the Ghostscript^® Postscript Executable Path normally goes.

DO NOT TRY TO PUT THE PATH TO THE ACROPLOTREPRO.EXE IN THE "OTHER SOFTWARE" OR IN THE "OCÉ POSTSCRIPT3 CONVERTER." ACROPLOT REPRO IS DESIGNED TO WORK AS AN EXACT GHOSTSCRIPT REPLACEMENT AND HENCE NEEDS TO GO THERE.

The path to AcroPlot Repro™ is typically: C:\Program Files\AcroPlotRepro\AcroPlotRepro.exe